Valley Pan-Outside Corner-Window Casing-Inside Corner........................Plenum-Valley Pan-Cricket Flashing-Wide Ridge/Hip Cap
Basic Operation
Take a few moments to familiarize yourself with this tool. When bending metal, we recommend making practice bends with scrap material until you are satisfied with results.
After inserting material into brake, rotate handle to clamp in place.
Bend upward to desired angle.
Rotate handle toward you to unclamp material. Remove material from brake and position for next bend.
From Van Mark's Instructional Series Bending Animations Page For Demonstration Only. Other examples may depict different Van Mark Brakes used to achieve the same results.
