|
|
|
|
|
|
|
|
|
| Sure Cut 90™ |
|
|
|
|
|
 |
 |
|
|
| With saw table inverted, install leg plates using 4 each #10 sheet metal screws. Install center plate to leg plate using 4 each #10 sheet metal screws. Install leg clamps over legs as shown using 4 each #10 sheet metal screws. Repeat on opposite end. Unfold legs and stand table in upright position. |
Loosen all 4 hex bolts located at opposing ends of each saw track. Use a light spray lubricant in channels if tightness occurs while trying to move the tracks. |
|
 |
|
 |
|
|
With saw unplugged, extend saw blade into center of blade slot as shown. Note: During normal operations, the saw blade needs only to break the plane of the table top slightly in order to cut through most materials. Periodically check blade elevation and readjust as needed. |
|
|
|
| Position tracks snug to edges of saw shoe remembering to maintain saw blade in center of slot. Extend unplugged saw up and down saw tracks to ensure saw blade stays in center of slot. Tighten all 4 hex bolts securely and recheck saw blade is still center in slot. |
|
 |
 |
|
|
|
The SureCut extension is used from the left end of the table for additional support of materials. The built-in tape rule can be aligned with the tape rule in the back fence for a continual measurement. Use the lock screw to lock the extension in place. |
|
The SureCut miter bar is designed to provide a 45 degree cutting guide for common widths of various materials. For situations where more complex angles are required, we recommend an upgrade to our
Trim-A-Table® |
|
|
|
|
|
|
|
|
|
|
|
|
|
