Prev
/
Front
/
Next
Operation
This tool is designed to require very low or little maintenance. Always protect tool from excessive moisture, dirt or debris and damage from impact.
Place material into brake
*
and align desired cut 1 1/2 inches from stainless steel edge. Clamp in place to prevent shifting while cutting.
Facing the front of the brake, place your TrimCutter to the right end of the brake and engage the track bearings to the guide tracks as shown above.
In one complete steady motion, extend your TrimCutter along guide tracks until entire piece is severed from material. Remove tool from brake.
*
TrimCutter
™
will not work on Trim-A-Brake I
™
& II
™
or J Brakes
™
. Ask for details before purchase.
