You Are Here!
Setup
Right Click in Image Field to Reveal These Options
Download for viewing parts list.
Email Us
Step 1. Remove and lay out contents of box. Space the End Assemblies apart and install Cross Members by aligning holes with threaded holes in End Assemblies and tightening T knobs snugly in place..
Step 2. With the Axle Hub of Wheel facing inside to Steel Leg, insert Axle Bolt 06 through Wheel and thread Flange Nut 09 onto threads (do not tighten, leave loose allowing wheel to turn)
Note: Ensure Flange also faces Steel Leg. Extend Axle Bolt threads through bottom hole in Leg Support and top hole in End Assembly. Place Washer 08 over Axle Bolt and tighten against Flange Nut with Nyloc Nut 07. Repeat same steps with opposite Wheel.
NOTE: The Axle Hub of each Wheel extends outward from the rear of the Wheel toward the Steel Channels of each Leg. Thread the Flange Nut on backwards as shown and tighten until Wheel turns freely but does not wobble.
Step 3. Your UniStand™ Adjustable™ comes with the Leg Supports installed. Follow the above detail for level position after installing Wheels.
Click Here To Print The User's Guide (pdf)
Brake and Saw Table Attachment
1. Insert T knobs through slots in latch-plate and thread into opening in rear of end assembly. Leave latch-plate in this position for now.
2. Place lip edge of front base rail fully into retainer. Lower brake fully onto mounting surface.
3. Extend latch plate over rear lip edge and firmly tighten T knobs to hold brake or tool in place.
1. As seen in step 2, Insert front lip edge of tool into retainer. Rest back lip edge onto mounting surface. Tighten latch plate.