Link to Van Mark Home page
Link to Van Mark Brakes page
Link to Van Mark Brake Accessories page
Button link to Van Mark Saw Tables page
Button link to Van Mark Slitters page
Button link to Van Mark Roofing Products page
Button link to Van Mark tools and parts purchase page
Button link to Van Mark image, literature and video page
Button link to Van Mark Trim-A-Gutter Tools and Accessories page
Button link to Van Mark parts page
Button link to Van Mark parts page
Button link to Van Mark Customer Service page
Button link to Van Mark submit new ideas form
Button link to Van Mark submit Resume form
Button link to Van Mark closeouts
Button link to Email Us form
You Are Here!

Coil Dispenser Setup
Figure 1-Lock cross members. Image of figure 2 1. Unpack contents of box and lay out for assembly.

2. Unfold legs from stand and push down on center of
cross members to lock in place (Fig 1).

3. Install blocks shown in Fig 2 by first making sure top
holes are off-set toward center of stand. Align top holes
of each block with holes on bottom of frame. Start 2 screws
per block (do not tighten as yet).

4. Align bottom holes of blocks with holes in stand. Place washers onto screws and install through bottom of stand
and into mounting blocks. Once these 4 screws are started,
go back and tighten all 8 screws mentioned here.
Operation
Load coil between rollers and under score guide.
1. Remove pinch roller and place coil onto rollers as shown in Figure 3. Replace pinch roller to prevent coil unraveling.
2. Feed the coil down between the rollers and out between the score guide and score bed (see parts list for additional view).
3. Place unit approximately 18 inches from brake (see right).
4. Pull coil from unit into brake. Note: Coil should pass freely through brake without hitting brake castings. Score or cut to desired length.

 As seen below, center unit so coil passes freely through brake. Leave enough room between tools to operate QuickScore™ or TrimCutter™.

Center coil so material pulls freely through brake.

Using With QuickScore™
Step 1 Extend to length.
Step 2 Flex along score.
Step 3 Separate along score.
Extend coil to desired length. Engage QuickScore blade against material . Run blade along entire width of material. Flex coil down then up along the score line Coil will separate along score line.

Using With TrimCutter™
Step 1 Extend coil to length.
 1. Extend coil to desired length.

2. Place TrimCutter onto guide tracks. With one steady motion, extend tool along entire width of coil until cutting wheels clear material. Re-move tool when not in use.
Step 2 Run TrimCutter along width of coil.
Call Toll-Free 1-800-826-6275