|
Replacing Blade-Changing Blade Position
|
QuickScore™ now has 2 blade positions to accommodate use on the Mark I and IV Series brakes as well as the new TrimMaster® Series. QuickScore™ comes with the blade preset to the outside, or Mark I & IV position.
Replacing blade. To change the blade position for use with a new TrimMaster® brake, please follow the steps below. If simply changing the blade, follow steps 1 thru 4 then reverse steps to complete the change. Note: If blade is behind spacer (as in step 7), it is set for TrimMaster® use. If in front, blade is set for Mark I & Mark IV use.
Caution: This tool uses extremely sharp utility blades and requires caution/care during all phases of use, including changing the blade described below. Failure to adhere can lead to injury & damage to objects. |
|
|
|
|
|
Steady tool on flat surface. Extend knife block and remove slotted screw.
|
Extend knife cover down to expose internal blade components.
|
Carefully remove knife shim and set aside.
|
|
|
|
|
|
Remove blade, keeping fingers away from sharp edges.
|
Next, remove spacer from knife block as shown and set aside.
|
Reinstall blade into knife block using the first alignment notch on blade.
|
|
|
|
|
|
Insert the spacer as shown. Note: Arrow indicates blade storage area.
|
Reinstall knife shim over spacer.
|
Slide knife cover back into place. Insert screw snugly into place. Be careful not to cross-thread or strip screw.
|
