Link to Van Mark Home page
Link to Van Mark Brakes page
Link to Van Mark Brake Accessories page
Button link to Van Mark Saw Tables page
Button link to Van Mark Slitters page
Button link to Van Mark Roofing Products page
Button link to Van Mark tools and parts purchase page
Button link to Van Mark image, literature and video page
Button link to Van Mark Trim-A-Gutter Tools and Accessories page
Button link to Van Mark parts page
Button link to Van Mark parts page
Button link to Van Mark Customer Service page
Button link to Van Mark submit new ideas form
Button link to Van Mark submit Resume form
Button link to Van Mark closeouts
Button link to Email Us form
Image of Unileg logo
Two New UniLeg Models to stand on
You Are Here!
For use with Van Mark Brakes, Trim-A-Gutter™ and Trim-A-Table™ Saw Tables.
No Tools Required for setup. Please read all instructions carefully.
Mark I Series™ and Mark II TrimMaster® Brake Installation
Image of TM10 Unileg 1, Step 1 Image of TM10 Unileg 1, Step 2
Step 1. As shown, position UniLeg™ under brake with retainers slightly forward of the base rail lips. Lower brake onto flat surface of the retainers and slide forward into retainer channels. Step 2. Extend latch plate over rear base rail lip and tighten securely with T knob. During use, periodically check tightness of T knobs. Repeat these steps with opposite UniLeg™.
Trim-A-Brake™ Installation Trim-A-Table™ Installation
Image of T1050, Step 1 Image of UniLeg 1, Step 1
Lower Trim-A-Brake™ onto flat top surface of UniLeg™ making sure to insert front base rail lip into retainer channel as in Step 1 above. Place latch plate lip over rear base rail lip as shown (rear of the latch plate should be seated into grooves in rear retainer). Tighten T knob and repeat on opposite end of brake. Lower Trim-A-Table™ onto flat top surface of UniLeg™ making sure to insert front base rail lip into retainer channel as in Step 1 above. Place latch plate lip over rear base rail lip as shown. Tighten the T knob and repeat on opposite end of tool. Check T knobs often and tighten as needed.
Trim-A-Gutter™ Installation Examples
Image of Trim-A-Gutter, Step 1
Image of TM10 and UniLeg 1..Image of Trim-A-Gutter and UniLeg 1
As shown above, once you have installed both UniLeg™ supports, position each 1/4 to 1/3 (of the tool length) in from each end of tool.

For Trim-A-Gutter™ (shown left), position legs even with ends of base rails. Tighten T knobs and retighten as needed.